Home › Code lookup › P0960
Powertrain code · Transmission

P0960 Pressure Control Solenoid A Control Circuit/Open

How urgent? Get it checked in the next few days

What it means

The computer found an electrical problem in the circuit for the pressure control solenoid A, which adjusts hydraulic pressure inside the transmission so the clutches apply firmly and smoothly.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the wiring and connector at the pressure control solenoid for damage, rubbing or corrosion
  2. Check related fuses, power and ground with a meter
  3. Test the pressure control solenoid against the factory specification before replacing it

Signs you may notice

  • Check engine light on
  • Harsh, delayed or slipping shifts
  • Transmission may be stuck in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed pressure control solenoid
  • CommonBroken or damaged wiring to the pressure control solenoid
  • CommonLoose, corroded or water-damaged connector
  • PossibleBlown fuse or missing power or ground
  • PossibleFaulty transmission or engine computer (rare)

Typical repair once the cause is confirmed

Repair any wiring or connector fault found; if the circuit tests good, replace the pressure control solenoid.

Repair costInsufficient verified pricing for this vehicle and repair
Replace pressure control solenoid. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0960 mean?

The computer found an electrical problem in the circuit for the pressure control solenoid A, which adjusts hydraulic pressure inside the transmission so the clutches apply firmly and smoothly.

Can I drive with code P0960?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0960?

Common possibilities to test include: failed pressure control solenoid; broken or damaged wiring to the pressure control solenoid; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.