Home › Code lookup › P0962
Powertrain code · Transmission

P0962 Pressure Control Solenoid A Control Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the pressure control solenoid A circuit that is lower than it should be. The pressure control solenoid adjusts hydraulic pressure inside the transmission so the clutches apply firmly and smoothly.

Can I keep driving?

Usually drivable with care to a shop soon, but shifts may be harsh, late or slipping and it may stay in one gear. Avoid highways if it won't shift right. If it slips, flares in RPM or a transmission warning appears, keep driving to a minimum or have it towed.

What to test before replacing parts

Check the pressure control solenoid A circuit for a short to ground or open, measure solenoid resistance, and check the connector before replacing the solenoid or transmission computer.

  1. Inspect the pressure control solenoid wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the pressure control solenoid and see whether the reading changes

Signs you may notice

  • Check engine light on
  • Harsh, delayed or slipping shifts
  • Transmission may be stuck in one gear (limp mode)
  • Erratic shift timing

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed pressure control solenoid A
  • CommonDamaged or corroded wiring in the transmission harness
  • CommonLoose or poor-contact connector
  • PossibleBlown fuse or relay in the transmission circuit
  • PossibleFaulty transmission or engine computer

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the pressure control solenoid.

Repair costInsufficient verified pricing for this vehicle and repair
Replace pressure control solenoid. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0962 mean?

The computer sees a signal or voltage in the pressure control solenoid A circuit that is lower than it should be. The pressure control solenoid adjusts hydraulic pressure inside the transmission so the clutches apply firmly and smoothly.

Can I drive with code P0962?

Usually drivable with care to a shop soon, but shifts may be harsh, late or slipping and it may stay in one gear. Avoid highways if it won't shift right. If it slips, flares in RPM or a transmission warning appears, keep driving to a minimum or have it towed.

What causes P0962?

Common possibilities to test include: failed pressure control solenoid a; damaged or corroded wiring in the transmission harness; loose or poor-contact connector; blown fuse or relay in the transmission circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.