Home › Code lookup › P0977
Powertrain code · Transmission

P0977 Shift Solenoid B Control Circuit High

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the shift solenoid B circuit that is higher than it should be. The shift solenoid opens and closes oil passages so the transmission can change gears.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the shift solenoid circuit for an open wire or a short to voltage
  3. Test the shift solenoid against the factory specification

Signs you may notice

  • Check engine light on
  • Missing, late or harsh shifts
  • Transmission may stay in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the shift solenoid circuit
  • CommonFailed shift solenoid
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the shift solenoid.

Repair costInsufficient verified pricing for this vehicle and repair
Replace shift solenoid. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0977 mean?

The computer sees a signal or voltage in the shift solenoid B circuit that is higher than it should be. The shift solenoid opens and closes oil passages so the transmission can change gears.

Can I drive with code P0977?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0977?

Common possibilities to test include: open or broken wire in the shift solenoid circuit; failed shift solenoid; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.