P0983 Shift Solenoid D Control Circuit High
What it means
The computer sees a signal or voltage in the shift solenoid D circuit that is higher than it should be. The shift solenoid opens and closes oil passages so the transmission can change gears.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the shift solenoid circuit for an open wire or a short to voltage
- Test the shift solenoid against the factory specification
Signs you may notice
- Check engine light on
- Missing, late or harsh shifts
- Transmission may stay in one gear (limp mode)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the shift solenoid circuit
- CommonFailed shift solenoid
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the shift solenoid.
Common questions
What does P0983 mean?
The computer sees a signal or voltage in the shift solenoid D circuit that is higher than it should be. The shift solenoid opens and closes oil passages so the transmission can change gears.
Can I drive with code P0983?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0983?
Common possibilities to test include: open or broken wire in the shift solenoid circuit; failed shift solenoid; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.