P0984 Shift Solenoid E Control Circuit Range/Performance
What it means
The shift solenoid E is giving readings that don't match what the computer expects for the current conditions. The shift solenoid opens and closes oil passages so the transmission can change gears.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the transmission fluid level and condition
- Compare the shift solenoid reading with what it should be on a scan tool
- Inspect the wiring and connector for corrosion or damage
Signs you may notice
- Check engine light on
- Missing, late or harsh shifts
- Transmission may stay in one gear (limp mode)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing shift solenoid
- CommonLow, dirty or wrong-type transmission fluid
- PossibleSticking valve in the valve body
- PossibleHigh resistance in the wiring or connector
- PossibleControl module software needs an update
Typical repair once the cause is confirmed
Correct any fluid or wiring problem first; if the readings are still wrong, replace the shift solenoid.
Common questions
What does P0984 mean?
The shift solenoid E is giving readings that don't match what the computer expects for the current conditions. The shift solenoid opens and closes oil passages so the transmission can change gears.
Can I drive with code P0984?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0984?
Common possibilities to test include: failing shift solenoid; low, dirty or wrong-type transmission fluid; sticking valve in the valve body; high resistance in the wiring or connector. A shop should confirm the cause before replacing parts.