Home › Code lookup › P0989
Powertrain code · Transmission

P0989 Transmission Fluid Pressure Sensor/Switch E Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the transmission fluid pressure sensor/switch E circuit that is lower than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the pressure sensor/switch wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the pressure sensor/switch and see whether the reading changes

Signs you may notice

  • Check engine light on
  • Harsh, late or erratic shifting
  • Transmission may stay in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the pressure sensor/switch circuit
  • CommonFailed transmission fluid pressure sensor/switch (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the pressure sensor/switch.

Repair costInsufficient verified pricing for this vehicle and repair
Replace transmission fluid pressure sensor/switch. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0989 mean?

The computer sees a signal or voltage in the transmission fluid pressure sensor/switch E circuit that is lower than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I drive with code P0989?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0989?

Common possibilities to test include: wire shorted to ground in the pressure sensor/switch circuit; failed transmission fluid pressure sensor/switch (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.