Home › Code lookup › P2005
Powertrain code · Fuel and air

P2005 Intake Manifold Runner Control Stuck Open Bank 2

How urgent? Book a check when convenient

What it means

The flaps inside the intake manifold on bank 2 (the side of the engine opposite cylinder 1) seem stuck open. These flaps change how air flows into the engine to help power at different speeds.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Watch the actuator move (or not) when the engine is started or revved
  2. Check vacuum lines to the actuator if it is vacuum-operated

Signs you may notice

  • Check engine light on
  • Weaker power at low engine speeds
  • Rough or uneven idle in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonIntake runner flaps or linkage stuck with carbon buildup
  • CommonFailed intake manifold runner actuator
  • PossibleBroken flap, shaft or linkage inside the manifold
  • PossibleVacuum leak to a vacuum-operated actuator

Typical repair once the cause is confirmed

Clean or free up the runner flaps if possible; often the actuator or the whole intake manifold has to be replaced.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake manifold runner actuator. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P2005 mean?

The flaps inside the intake manifold on bank 2 (the side of the engine opposite cylinder 1) seem stuck open. These flaps change how air flows into the engine to help power at different speeds.

Can I drive with code P2005?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2005?

Common possibilities to test include: intake runner flaps or linkage stuck with carbon buildup; failed intake manifold runner actuator; broken flap, shaft or linkage inside the manifold; vacuum leak to a vacuum-operated actuator. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.