Home › Code lookup › P200B
Powertrain code · Fuel and air

P200B Intake Manifold Runner Performance Bank 2

How urgent? Book a check when convenient

What it means

The intake runner flaps on bank 2 (the side of the engine opposite cylinder 1) aren't moving the way the computer commands. They may be sticking, slow or not reaching the right position.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Watch the actuator and linkage move with a scan tool command
  2. Check for vacuum leaks or broken linkage

Signs you may notice

  • Check engine light on
  • Slightly weaker power at some engine speeds
  • Possible rough idle

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonCarbon buildup making the flaps stick
  • CommonWorn or failed runner actuator
  • PossibleBroken linkage or flap shaft
  • PossibleVacuum leak on a vacuum-operated system

Typical repair once the cause is confirmed

Free up or repair the flaps and linkage; replace the actuator or intake manifold if worn.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake manifold runner actuator. Prepare an itemized shop request.

Common questions

What does P200B mean?

The intake runner flaps on bank 2 (the side of the engine opposite cylinder 1) aren't moving the way the computer commands. They may be sticking, slow or not reaching the right position.

Can I drive with code P200B?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P200B?

Common possibilities to test include: carbon buildup making the flaps stick; worn or failed runner actuator; broken linkage or flap shaft; vacuum leak on a vacuum-operated system. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.