P2007 Intake Manifold Runner Control Stuck Closed Bank 2
What it means
The flaps inside the intake manifold on bank 2 (the side of the engine opposite cylinder 1) seem stuck closed. These flaps change how air flows into the engine to help power at different speeds.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Watch the actuator move (or not) when the engine is started or revved
- Check vacuum lines to the actuator if it is vacuum-operated
Signs you may notice
- Check engine light on
- Weaker power at higher engine speeds
- Rough or uneven idle in some cases
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonIntake runner flaps or linkage stuck with carbon buildup
- CommonFailed intake manifold runner actuator
- PossibleBroken flap, shaft or linkage inside the manifold
- PossibleVacuum leak to a vacuum-operated actuator
Typical repair once the cause is confirmed
Clean or free up the runner flaps if possible; often the actuator or the whole intake manifold has to be replaced.
Known on these vehicles
Common questions
What does P2007 mean?
The flaps inside the intake manifold on bank 2 (the side of the engine opposite cylinder 1) seem stuck closed. These flaps change how air flows into the engine to help power at different speeds.
Can I drive with code P2007?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2007?
Common possibilities to test include: intake runner flaps or linkage stuck with carbon buildup; failed intake manifold runner actuator; broken flap, shaft or linkage inside the manifold; vacuum leak to a vacuum-operated actuator. A shop should confirm the cause before replacing parts.