P200C Diesel Particulate Filter Over Temperature Bank 1
What it means
The diesel particulate filter on bank 1 (the side of the engine with cylinder 1) got hotter than it should. This can happen during a soot burn-off when too much soot or extra fuel burns at once.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check exhaust temperature sensor readings
- Check for leaking injectors or oil getting into the exhaust
Signs you may notice
- Check engine light on
- Reduced engine power
- Possible smell of hot exhaust
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonToo much soot in the filter burning at once
- CommonLeaking or dripping fuel injector adding raw fuel
- PossibleFaulty exhaust temperature sensor
- PossibleOil getting into the exhaust from a turbo or engine problem
Typical repair once the cause is confirmed
Fix the source of extra fuel or soot, then check the filter for heat damage; replace the filter if it is cracked.
Common questions
What does P200C mean?
The diesel particulate filter on bank 1 (the side of the engine with cylinder 1) got hotter than it should. This can happen during a soot burn-off when too much soot or extra fuel burns at once.
Can I drive with code P200C?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P200C?
Common possibilities to test include: too much soot in the filter burning at once; leaking or dripping fuel injector adding raw fuel; faulty exhaust temperature sensor; oil getting into the exhaust from a turbo or engine problem. A shop should confirm the cause before replacing parts.