Home › Code lookup › P2008
Powertrain code · Fuel and air

P2008 Intake Manifold Runner Control Circuit/Open Bank 1

How urgent? Book a check when convenient

What it means

The engine computer can't properly control the intake manifold runner control on bank 1, which moves flaps in the intake to change how air flows into the engine. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the runner control actuator connector and wiring
  2. Check for power at the connector and measure the part's resistance

Signs you may notice

  • Check engine light on
  • Slightly weaker power at some engine speeds

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed intake manifold runner control actuator
  • CommonBroken wire or unplugged connector
  • PossibleBlown fuse or bad relay feeding the circuit
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the intake manifold runner control actuator.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake manifold runner actuator. Prepare an itemized shop request.

Common questions

What does P2008 mean?

The engine computer can't properly control the intake manifold runner control on bank 1, which moves flaps in the intake to change how air flows into the engine. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I drive with code P2008?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2008?

Common possibilities to test include: failed intake manifold runner control actuator; broken wire or unplugged connector; blown fuse or bad relay feeding the circuit; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.