P2006 Intake Manifold Runner Control Stuck Closed Bank 1
What it means
The flaps inside the intake manifold on bank 1 (the side of the engine with cylinder 1) seem stuck closed. These flaps change how air flows into the engine to help power at different speeds.
Can I keep driving?
Usually drivable while you arrange a repair, with weaker power at higher RPM. If the engine misfires, runs rough or you hear loud rattling from the intake, get it checked sooner, since broken parts could be drawn into the engine on some designs.
What to test before replacing parts
Check whether the runners move when commanded and inspect for carbon buildup, a seized shaft, a failed actuator or a vacuum leak, and verify the position sensor before replacing the manifold.
- Watch the actuator move (or not) when the engine is started or revved
- Check vacuum lines to the actuator if it is vacuum-operated
- Look for broken linkage or a binding flap shaft
Signs you may notice
- Check engine light on
- Weaker power at higher engine speeds
- Rough or uneven idle in some cases
- Possible rattle or ticking from the intake
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonIntake runner flaps or linkage stuck with carbon buildup
- CommonFailed intake manifold runner actuator
- PossibleBroken flap, shaft or linkage inside the manifold
- PossibleVacuum leak to a vacuum-operated actuator
- PossibleWiring or connector fault at the actuator
Typical repair once the cause is confirmed
Clean or free up the runner flaps if possible; often the actuator or the whole intake manifold has to be replaced.
Known on these vehicles
Common questions
What does P2006 mean?
The flaps inside the intake manifold on bank 1 (the side of the engine with cylinder 1) seem stuck closed. These flaps change how air flows into the engine to help power at different speeds.
Can I drive with code P2006?
Usually drivable while you arrange a repair, with weaker power at higher RPM. If the engine misfires, runs rough or you hear loud rattling from the intake, get it checked sooner, since broken parts could be drawn into the engine on some designs.
What causes P2006?
Common possibilities to test include: intake runner flaps or linkage stuck with carbon buildup; failed intake manifold runner actuator; broken flap, shaft or linkage inside the manifold; vacuum leak to a vacuum-operated actuator. A shop should confirm the cause before replacing parts.