Home › Code lookup › P2004
Powertrain code · Fuel and air

P2004 Intake Manifold Runner Control Stuck Open Bank 1

How urgent? Book a check when convenient

What it means

The flaps inside the intake manifold on bank 1 (the side of the engine with cylinder 1) seem stuck open. These flaps change how air flows into the engine to help power at different speeds.

Can I keep driving?

Usually fine to drive normally while you arrange a repair; low-speed power may be weaker or idle rough. If you hear loud rattling from the intake or the engine starts misfiring or running poorly, get it checked sooner, since broken runner parts can be pulled into the engine on some designs.

What to test before replacing parts

Command the runner control on and off with a scanner and watch it move; check the vacuum supply or motor, linkage and position sensor, and look for broken runner parts.

  1. Watch the actuator move (or not) when the engine is started or revved
  2. Check vacuum lines to the actuator if it is vacuum-operated
  3. Look for broken linkage or a binding flap shaft

Signs you may notice

  • Check engine light on
  • Weaker power at low engine speeds
  • Rough or uneven idle in some cases
  • Possible rattle or ticking from the intake

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonIntake runner flaps or linkage stuck with carbon buildup
  • CommonFailed intake manifold runner actuator
  • PossibleBroken flap, shaft or linkage inside the manifold
  • PossibleVacuum leak to a vacuum-operated actuator
  • PossibleWiring or connector fault at the actuator

Typical repair once the cause is confirmed

Clean or free up the runner flaps if possible; often the actuator or the whole intake manifold has to be replaced.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake manifold runner actuator. Prepare an itemized shop request.

Where it shows up

  • Well known on Mercedes-Benz V6 and V8 engines (M272/M273) with intake manifold flap problems

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P2004 mean?

The flaps inside the intake manifold on bank 1 (the side of the engine with cylinder 1) seem stuck open. These flaps change how air flows into the engine to help power at different speeds.

Can I drive with code P2004?

Usually fine to drive normally while you arrange a repair; low-speed power may be weaker or idle rough. If you hear loud rattling from the intake or the engine starts misfiring or running poorly, get it checked sooner, since broken runner parts can be pulled into the engine on some designs.

What causes P2004?

Common possibilities to test include: intake runner flaps or linkage stuck with carbon buildup; failed intake manifold runner actuator; broken flap, shaft or linkage inside the manifold; vacuum leak to a vacuum-operated actuator. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.