Home › Code lookup › P2012
Powertrain code · Fuel and air

P2012 Intake Manifold Runner Control Circuit Low Bank 2

How urgent? Book a check when convenient

What it means

The control circuit for the intake manifold runner control on bank 2 is reading low voltage. This part moves flaps in the intake to change how air flows into the engine. A wire shorted to ground or a shorted part is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the runner control actuator wiring for rubbed-through insulation
  2. Measure the runner control actuator resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Slightly weaker power at some engine speeds

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire shorted to ground
  • CommonInternally shorted intake manifold runner control actuator
  • PossibleDamaged connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the intake manifold runner control actuator.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake manifold runner actuator. Prepare an itemized shop request.

Common questions

What does P2012 mean?

The control circuit for the intake manifold runner control on bank 2 is reading low voltage. This part moves flaps in the intake to change how air flows into the engine. A wire shorted to ground or a shorted part is the usual reason.

Can I drive with code P2012?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2012?

Common possibilities to test include: control wire shorted to ground; internally shorted intake manifold runner control actuator; damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.