P2013 Intake Manifold Runner Control Circuit High Bank 2
What it means
The control circuit for the intake manifold runner control on bank 2 is reading high voltage. This part moves flaps in the intake to change how air flows into the engine. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the runner control actuator wiring for shorts to other wires
- Measure the runner control actuator resistance and compare with spec
Signs you may notice
- Check engine light on
- Slightly weaker power at some engine speeds
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed intake manifold runner control actuator
- CommonControl wire shorted to a power source
- PossibleOpen circuit or corroded connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the intake manifold runner control actuator.
Common questions
What does P2013 mean?
The control circuit for the intake manifold runner control on bank 2 is reading high voltage. This part moves flaps in the intake to change how air flows into the engine. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I drive with code P2013?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2013?
Common possibilities to test include: failed intake manifold runner control actuator; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.