Home › Code lookup › P2014
Powertrain code · Fuel and air

P2014 Intake Manifold Runner Position Sensor/Switch Circuit Bank 1

How urgent? Book a check when convenient

What it means

The engine computer has found a problem in the circuit for the intake manifold runner position sensor on bank 1, which tells the computer where the intake flaps are. It usually points to wiring, a connector or the sensor itself.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the runner position sensor connector and wiring for damage or corrosion
  2. Check the sensor power, ground and signal with a meter

Signs you may notice

  • Check engine light on
  • Slightly weaker power at some engine speeds

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty runner position sensor (often part of the actuator)
  • CommonDamaged, corroded or unplugged connector
  • PossibleBroken or chafed wiring
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the runner position sensor (often part of the actuator).

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake runner position sensor or actuator. Prepare an itemized shop request.

Common questions

What does P2014 mean?

The engine computer has found a problem in the circuit for the intake manifold runner position sensor on bank 1, which tells the computer where the intake flaps are. It usually points to wiring, a connector or the sensor itself.

Can I drive with code P2014?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2014?

Common possibilities to test include: faulty runner position sensor (often part of the actuator); damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.