Home › Code lookup › P2015
Powertrain code · Fuel and air

P2015 Intake Manifold Runner Position Sensor/Switch Circuit Range/Performance Bank 1

How urgent? Book a check when convenient

What it means

The sensor that reports the position of the intake manifold flaps on bank 1 is giving readings that don't match what the computer commanded. Often the flaps or their linkage are actually stuck or broken.

Can I keep driving?

Usually drivable normally; most people notice little more than a slight change in power. Get it checked when convenient. If the engine starts running rough, misfiring or you hear rattling from the intake, have it looked at sooner.

What to test before replacing parts

Compare the runner position sensor reading to actual runner movement, and check the sensor wiring and linkage for wear or a broken clip before replacing the intake manifold.

  1. Look at the runner linkage for a popped-off or broken arm
  2. Watch the position reading change while commanding the flaps
  3. Inspect the sensor connector and wiring

Signs you may notice

  • Check engine light on
  • Slightly weaker power at low or high speeds
  • Rough idle in some cases
  • Often no other symptoms

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBroken or worn intake runner linkage or flap
  • CommonFailed runner position sensor or actuator
  • PossibleCarbon buildup making the flaps stick
  • PossibleWiring or connector problem
  • PossibleVacuum leak on a vacuum-operated system

Typical repair once the cause is confirmed

Repair the linkage if possible; otherwise replace the actuator/sensor or, on some engines, the intake manifold.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake runner actuator or intake manifold. Prepare an itemized shop request.

Where it shows up

  • Very common on Mercedes-Benz M272 V6 engines and some VW/Audi 2.0T engines

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P2015 mean?

The sensor that reports the position of the intake manifold flaps on bank 1 is giving readings that don't match what the computer commanded. Often the flaps or their linkage are actually stuck or broken.

Can I drive with code P2015?

Usually drivable normally; most people notice little more than a slight change in power. Get it checked when convenient. If the engine starts running rough, misfiring or you hear rattling from the intake, have it looked at sooner.

What causes P2015?

Common possibilities to test include: broken or worn intake runner linkage or flap; failed runner position sensor or actuator; carbon buildup making the flaps stick; wiring or connector problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.