Home › Code lookup › P2016
Powertrain code · Fuel and air

P2016 Intake Manifold Runner Position Sensor/Switch Circuit Low Bank 1

How urgent? Book a check when convenient

What it means

The signal from the intake manifold runner position sensor on bank 1 is lower than the computer expects. This sensor tells the computer where the intake flaps are. A wire shorted to ground or a failed sensor is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the runner position sensor wiring for rubbed-through or pinched spots
  2. Unplug the sensor and see if the reading changes, which helps separate wiring from sensor

Signs you may notice

  • Check engine light on
  • Slightly weaker power at some engine speeds

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal or reference wire shorted to ground
  • CommonFailed runner position sensor (often part of the actuator)
  • PossibleCorroded or damaged connector
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the runner position sensor (often part of the actuator).

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake runner position sensor or actuator. Prepare an itemized shop request.

Common questions

What does P2016 mean?

The signal from the intake manifold runner position sensor on bank 1 is lower than the computer expects. This sensor tells the computer where the intake flaps are. A wire shorted to ground or a failed sensor is the usual reason.

Can I drive with code P2016?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2016?

Common possibilities to test include: signal or reference wire shorted to ground; failed runner position sensor (often part of the actuator); corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.