P2021 Intake Manifold Runner Position Sensor/Switch Circuit Low Bank 2
What it means
The signal from the intake manifold runner position sensor on bank 2 is lower than the computer expects. This sensor tells the computer where the intake flaps are. A wire shorted to ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the runner position sensor wiring for rubbed-through or pinched spots
- Unplug the sensor and see if the reading changes, which helps separate wiring from sensor
Signs you may notice
- Check engine light on
- Slightly weaker power at some engine speeds
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal or reference wire shorted to ground
- CommonFailed runner position sensor (often part of the actuator)
- PossibleCorroded or damaged connector
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the runner position sensor (often part of the actuator).
Common questions
What does P2021 mean?
The signal from the intake manifold runner position sensor on bank 2 is lower than the computer expects. This sensor tells the computer where the intake flaps are. A wire shorted to ground or a failed sensor is the usual reason.
Can I drive with code P2021?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2021?
Common possibilities to test include: signal or reference wire shorted to ground; failed runner position sensor (often part of the actuator); corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.