P2022 Intake Manifold Runner Position Sensor/Switch Circuit High Bank 2
What it means
The signal from the intake manifold runner position sensor on bank 2 is higher than the computer expects. This sensor tells the computer where the intake flaps are. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the runner position sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- Slightly weaker power at some engine speeds
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed runner position sensor (often part of the actuator)
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the runner position sensor (often part of the actuator).
Common questions
What does P2022 mean?
The signal from the intake manifold runner position sensor on bank 2 is higher than the computer expects. This sensor tells the computer where the intake flaps are. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P2022?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2022?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed runner position sensor (often part of the actuator); wire shorted to a power source. A shop should confirm the cause before replacing parts.