Home › Code lookup › P2023
Powertrain code · Fuel and air

P2023 Intake Manifold Runner Position Sensor/Switch Circuit Intermittent Bank 2

How urgent? Book a check when convenient

What it means

The signal from the intake manifold runner position sensor on bank 2 keeps dropping out or jumping around. This sensor tells the computer where the intake flaps are. A loose connection or a damaged wire is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the harness and connector while watching live data for dropouts
  2. Inspect the runner position sensor wiring along its whole route

Signs you may notice

  • Check engine light on
  • Slightly weaker power at some engine speeds

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector
  • CommonChafed wire that opens or shorts as the engine moves
  • PossibleFailing runner position sensor (often part of the actuator)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the runner position sensor (often part of the actuator).

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake runner position sensor or actuator. Prepare an itemized shop request.

Common questions

What does P2023 mean?

The signal from the intake manifold runner position sensor on bank 2 keeps dropping out or jumping around. This sensor tells the computer where the intake flaps are. A loose connection or a damaged wire is the usual reason.

Can I drive with code P2023?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2023?

Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing runner position sensor (often part of the actuator). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.