Home › Code lookup › P2027
Powertrain code · Emissions

P2027 Evaporative Emissions (EVAP) Fuel Vapor Temperature Sensor Circuit High Voltage

How urgent? Book a check when convenient

What it means

The signal from the EVAP fuel vapor temperature sensor is higher than the computer expects. This sensor measures the temperature of fuel vapor in the evaporative emissions system. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the vapor temperature sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed fuel vapor temperature sensor
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the fuel vapor temperature sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel vapor temperature sensor. Prepare an itemized shop request.

Common questions

What does P2027 mean?

The signal from the EVAP fuel vapor temperature sensor is higher than the computer expects. This sensor measures the temperature of fuel vapor in the evaporative emissions system. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P2027?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2027?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed fuel vapor temperature sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.