P2033 Exhaust Gas Temperature Sensor Circuit High Bank 1 Sensor 2
What it means
The signal from the exhaust gas temperature sensor (bank 1, sensor 2) is higher than the computer expects. This sensor measures exhaust heat to protect the turbo, catalytic converter or particulate filter. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the EGT sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- Particulate filter cleaning may be blocked on diesels
- Possible reduced power on some vehicles
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed exhaust gas temperature sensor
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the exhaust gas temperature sensor.
Common questions
What does P2033 mean?
The signal from the exhaust gas temperature sensor (bank 1, sensor 2) is higher than the computer expects. This sensor measures exhaust heat to protect the turbo, catalytic converter or particulate filter. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P2033?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2033?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed exhaust gas temperature sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.