Home › Code lookup › P2036
Powertrain code · Emissions

P2036 Exhaust Gas Temperature Sensor Circuit High Bank 2 Sensor 2

How urgent? Book a check when convenient

What it means

The signal from the exhaust gas temperature sensor (bank 2, sensor 2) is higher than the computer expects. This sensor measures exhaust heat to protect the turbo, catalytic converter or particulate filter. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the EGT sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • Particulate filter cleaning may be blocked on diesels
  • Possible reduced power on some vehicles

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed exhaust gas temperature sensor
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the exhaust gas temperature sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace exhaust gas temperature sensor. Prepare an itemized shop request.

Common questions

What does P2036 mean?

The signal from the exhaust gas temperature sensor (bank 2, sensor 2) is higher than the computer expects. This sensor measures exhaust heat to protect the turbo, catalytic converter or particulate filter. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P2036?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2036?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed exhaust gas temperature sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.