P2039 Reductant Injection Air Pressure Sensor Circuit Low Input
What it means
The signal from the reductant injection air pressure sensor is lower than the computer expects. This sensor monitors the air used to help spray diesel exhaust fluid (DEF) into the exhaust. A wire shorted to ground or a failed sensor is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the air pressure sensor wiring for rubbed-through or pinched spots
- Unplug the sensor and see if the reading changes, which helps separate wiring from sensor
Signs you may notice
- Check engine light on
- DEF or emissions warning on the dash
- A countdown to reduced speed may start if not repaired
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal or reference wire shorted to ground
- CommonFailed reductant air pressure sensor
- PossibleCorroded or damaged connector
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the reductant air pressure sensor.
Common questions
What does P2039 mean?
The signal from the reductant injection air pressure sensor is lower than the computer expects. This sensor monitors the air used to help spray diesel exhaust fluid (DEF) into the exhaust. A wire shorted to ground or a failed sensor is the usual reason.
Can I drive with code P2039?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2039?
Common possibilities to test include: signal or reference wire shorted to ground; failed reductant air pressure sensor; corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.