P203D Reductant Level Sensor Circuit High
What it means
The signal from the reductant (DEF) level sensor is higher than the computer expects. This sensor tells the computer how much diesel exhaust fluid is in the tank. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the DEF level sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- DEF or emissions warning on the dash
- A countdown to reduced speed may start if not repaired
- DEF gauge reads wrong
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed DEF level sensor (usually part of the tank sender)
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the DEF level sensor (usually part of the tank sender).
Common questions
What does P203D mean?
The signal from the reductant (DEF) level sensor is higher than the computer expects. This sensor tells the computer how much diesel exhaust fluid is in the tank. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P203D?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P203D?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed def level sensor (usually part of the tank sender); wire shorted to a power source. A shop should confirm the cause before replacing parts.