P2041 Reductant Injection Air Pressure Sensor Circuit Intermittent
What it means
The signal from the reductant injection air pressure sensor keeps dropping out or jumping around. This sensor monitors the air used to help spray diesel exhaust fluid (DEF) into the exhaust. A loose connection or a damaged wire is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Wiggle the harness and connector while watching live data for dropouts
- Inspect the air pressure sensor wiring along its whole route
Signs you may notice
- Check engine light on
- DEF or emissions warning on the dash
- A countdown to reduced speed may start if not repaired
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLoose or corroded connector
- CommonChafed wire that opens or shorts as the engine moves
- PossibleFailing reductant air pressure sensor
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the reductant air pressure sensor.
Common questions
What does P2041 mean?
The signal from the reductant injection air pressure sensor keeps dropping out or jumping around. This sensor monitors the air used to help spray diesel exhaust fluid (DEF) into the exhaust. A loose connection or a damaged wire is the usual reason.
Can I drive with code P2041?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2041?
Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing reductant air pressure sensor. A shop should confirm the cause before replacing parts.