Home › Code lookup › P2044
Powertrain code · Emissions

P2044 Reductant Temperature Sensor Circuit Low Input

How urgent? Get it checked in the next few days

What it means

The signal from the reductant (DEF) temperature sensor is lower than the computer expects. This sensor measures the temperature of the diesel exhaust fluid so the system can heat it in cold weather. A wire shorted to ground or a failed sensor is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the DEF temperature sensor wiring for rubbed-through or pinched spots
  2. Unplug the sensor and see if the reading changes, which helps separate wiring from sensor

Signs you may notice

  • Check engine light on
  • DEF or emissions warning on the dash
  • A countdown to reduced speed may start if not repaired

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal or reference wire shorted to ground
  • CommonFailed DEF temperature sensor (often part of the tank sender)
  • PossibleCorroded or damaged connector
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the DEF temperature sensor (often part of the tank sender).

Repair costInsufficient verified pricing for this vehicle and repair
Replace DEF temperature sensor or tank sender. Prepare an itemized shop request.

Common questions

What does P2044 mean?

The signal from the reductant (DEF) temperature sensor is lower than the computer expects. This sensor measures the temperature of the diesel exhaust fluid so the system can heat it in cold weather. A wire shorted to ground or a failed sensor is the usual reason.

Can I drive with code P2044?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2044?

Common possibilities to test include: signal or reference wire shorted to ground; failed def temperature sensor (often part of the tank sender); corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.