Home › Code lookup › P2046
Powertrain code · Emissions

P2046 Reductant Temperature Sensor Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

The signal from the reductant (DEF) temperature sensor keeps dropping out or jumping around. This sensor measures the temperature of the diesel exhaust fluid so the system can heat it in cold weather. A loose connection or a damaged wire is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the harness and connector while watching live data for dropouts
  2. Inspect the DEF temperature sensor wiring along its whole route

Signs you may notice

  • Check engine light on
  • DEF or emissions warning on the dash
  • A countdown to reduced speed may start if not repaired

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector
  • CommonChafed wire that opens or shorts as the engine moves
  • PossibleFailing DEF temperature sensor (often part of the tank sender)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the DEF temperature sensor (often part of the tank sender).

Repair costInsufficient verified pricing for this vehicle and repair
Replace DEF temperature sensor or tank sender. Prepare an itemized shop request.

Common questions

What does P2046 mean?

The signal from the reductant (DEF) temperature sensor keeps dropping out or jumping around. This sensor measures the temperature of the diesel exhaust fluid so the system can heat it in cold weather. A loose connection or a damaged wire is the usual reason.

Can I drive with code P2046?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2046?

Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing def temperature sensor (often part of the tank sender). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.