P204A Reductant Pressure Sensor Circuit
What it means
The engine computer has found a problem in the circuit for the reductant (DEF) pressure sensor, which monitors the pressure of the diesel exhaust fluid being sent to the injector. It usually points to wiring, a connector or the sensor itself.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the DEF pressure sensor connector and wiring for damage or corrosion
- Check the sensor power, ground and signal with a meter
Signs you may notice
- Check engine light on
- DEF or emissions warning on the dash
- A countdown to reduced speed may start if not repaired
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty DEF pressure sensor (often part of the pump module)
- CommonDamaged, corroded or unplugged connector
- PossibleBroken or chafed wiring
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the DEF pressure sensor (often part of the pump module).
Common questions
What does P204A mean?
The engine computer has found a problem in the circuit for the reductant (DEF) pressure sensor, which monitors the pressure of the diesel exhaust fluid being sent to the injector. It usually points to wiring, a connector or the sensor itself.
Can I drive with code P204A?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P204A?
Common possibilities to test include: faulty def pressure sensor (often part of the pump module); damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.