Home › Code lookup › P204D
Powertrain code · Emissions

P204D Reductant Pressure Sensor Circuit High

How urgent? Get it checked in the next few days

What it means

The signal from the reductant (DEF) pressure sensor is higher than the computer expects. This sensor monitors the pressure of the diesel exhaust fluid being sent to the injector. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the DEF pressure sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • DEF or emissions warning on the dash
  • A countdown to reduced speed may start if not repaired

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed DEF pressure sensor (often part of the pump module)
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the DEF pressure sensor (often part of the pump module).

Repair costInsufficient verified pricing for this vehicle and repair
Replace DEF pump module or pressure sensor. Prepare an itemized shop request.

Common questions

What does P204D mean?

The signal from the reductant (DEF) pressure sensor is higher than the computer expects. This sensor monitors the pressure of the diesel exhaust fluid being sent to the injector. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P204D?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P204D?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed def pressure sensor (often part of the pump module); wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.