P2065 Fuel Level Sensor B Circuit
What it means
The engine computer has found a problem in the circuit for the fuel level sensor B, which reads the fuel level in the second half of a saddle-shaped fuel tank (used on many all-wheel-drive cars and trucks). It usually points to wiring, a connector or the sensor itself.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the fuel level sensor connector and wiring for damage or corrosion
- Check the sensor power, ground and signal with a meter
Signs you may notice
- Check engine light on
- Fuel gauge reads wrong or jumps around
- Low fuel warning may come on at the wrong time
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty fuel level sending unit B
- CommonDamaged, corroded or unplugged connector
- PossibleBroken or chafed wiring
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the fuel level sending unit B.
Common questions
What does P2065 mean?
The engine computer has found a problem in the circuit for the fuel level sensor B, which reads the fuel level in the second half of a saddle-shaped fuel tank (used on many all-wheel-drive cars and trucks). It usually points to wiring, a connector or the sensor itself.
Can I drive with code P2065?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2065?
Common possibilities to test include: faulty fuel level sending unit b; damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.