P2067 Fuel Level Sensor B Circuit Low
What it means
The signal from the fuel level sensor B is lower than the computer expects. This sensor reads the fuel level in the second half of a saddle-shaped fuel tank (used on many all-wheel-drive cars and trucks). A wire shorted to ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the fuel level sensor wiring for rubbed-through or pinched spots
- Unplug the sensor and see if the reading changes, which helps separate wiring from sensor
Signs you may notice
- Check engine light on
- Fuel gauge reads wrong or jumps around
- Low fuel warning may come on at the wrong time
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal or reference wire shorted to ground
- CommonFailed fuel level sending unit B
- PossibleCorroded or damaged connector
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the fuel level sending unit B.
Common questions
What does P2067 mean?
The signal from the fuel level sensor B is lower than the computer expects. This sensor reads the fuel level in the second half of a saddle-shaped fuel tank (used on many all-wheel-drive cars and trucks). A wire shorted to ground or a failed sensor is the usual reason.
Can I drive with code P2067?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2067?
Common possibilities to test include: signal or reference wire shorted to ground; failed fuel level sending unit b; corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.