P2068 Fuel Level Sensor B Circuit High
What it means
The signal from the fuel level sensor B is higher than the computer expects. This sensor reads the fuel level in the second half of a saddle-shaped fuel tank (used on many all-wheel-drive cars and trucks). An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the fuel level sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- Fuel gauge reads wrong or jumps around
- Low fuel warning may come on at the wrong time
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed fuel level sending unit B
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the fuel level sending unit B.
Common questions
What does P2068 mean?
The signal from the fuel level sensor B is higher than the computer expects. This sensor reads the fuel level in the second half of a saddle-shaped fuel tank (used on many all-wheel-drive cars and trucks). An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P2068?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2068?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed fuel level sending unit b; wire shorted to a power source. A shop should confirm the cause before replacing parts.