P2072 Electronic Throttle Control System Performance - Ice Blockage
What it means
The computer believes ice has formed in the throttle body and is keeping the throttle from moving normally. This tends to happen in freezing, wet weather.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Let the engine warm up fully and recheck
- Inspect the intake and crankcase vent hoses for water or blockage
Signs you may notice
- Check engine light on
- Reduced power or limp mode
- Throttle may not respond normally in cold weather
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonIce in the throttle body from moisture in freezing weather
- CommonWater entering the air intake
- PossibleFailing throttle body that sticks
- PossibleBlocked or leaking crankcase vent letting moisture into the intake
Typical repair once the cause is confirmed
Warm the vehicle to clear the ice and fix any source of water in the intake; replace the throttle body if it keeps sticking.
Common questions
What does P2072 mean?
The computer believes ice has formed in the throttle body and is keeping the throttle from moving normally. This tends to happen in freezing, wet weather.
Can I drive with code P2072?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2072?
Common possibilities to test include: ice in the throttle body from moisture in freezing weather; water entering the air intake; failing throttle body that sticks; blocked or leaking crankcase vent letting moisture into the intake. A shop should confirm the cause before replacing parts.