P2079 Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit Intermittent
What it means
The signal from the intake manifold tuning valve position sensor keeps dropping out or jumping around. This sensor reports the position of the valve that switches the path air takes through the intake. A loose connection or a damaged wire is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Wiggle the harness and connector while watching live data for dropouts
- Inspect the tuning valve wiring along its whole route
Signs you may notice
- Check engine light on
- Slightly weaker power at some engine speeds
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLoose or corroded connector
- CommonChafed wire that opens or shorts as the engine moves
- PossibleFailing intake manifold tuning valve (sensor is usually built in)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the intake manifold tuning valve (sensor is usually built in).
Common questions
What does P2079 mean?
The signal from the intake manifold tuning valve position sensor keeps dropping out or jumping around. This sensor reports the position of the valve that switches the path air takes through the intake. A loose connection or a damaged wire is the usual reason.
Can I drive with code P2079?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2079?
Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing intake manifold tuning valve (sensor is usually built in). A shop should confirm the cause before replacing parts.