P2085 Exhaust Gas Temperature Sensor Circuit Intermittent Bank 1 Sensor 2
What it means
The signal from the exhaust gas temperature sensor (bank 1, sensor 2) keeps dropping out or jumping around. This sensor measures exhaust heat to protect the turbo, catalytic converter or particulate filter. A loose connection or a damaged wire is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Wiggle the harness and connector while watching live data for dropouts
- Inspect the EGT sensor wiring along its whole route
Signs you may notice
- Check engine light on
- Particulate filter cleaning may be blocked on diesels
- Possible reduced power on some vehicles
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLoose or corroded connector
- CommonChafed wire that opens or shorts as the engine moves
- PossibleFailing exhaust gas temperature sensor
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the exhaust gas temperature sensor.
Common questions
What does P2085 mean?
The signal from the exhaust gas temperature sensor (bank 1, sensor 2) keeps dropping out or jumping around. This sensor measures exhaust heat to protect the turbo, catalytic converter or particulate filter. A loose connection or a damaged wire is the usual reason.
Can I drive with code P2085?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2085?
Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing exhaust gas temperature sensor. A shop should confirm the cause before replacing parts.