P2093 "A" Camshaft Position Actuator Control Circuit High Bank 2
What it means
The control circuit for the camshaft timing control solenoid ("A" camshaft, bank 2) is reading high voltage. This part uses engine oil to adjust camshaft timing (variable valve timing). A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the cam timing solenoid wiring for shorts to other wires
- Measure the cam timing solenoid resistance and compare with spec
Signs you may notice
- Check engine light on
- Rough idle or stalling in some cases
- Less power or poorer fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed camshaft timing (VVT) solenoid
- CommonControl wire shorted to a power source
- PossibleOpen circuit or corroded connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the camshaft timing (VVT) solenoid.
Common questions
What does P2093 mean?
The control circuit for the camshaft timing control solenoid ("A" camshaft, bank 2) is reading high voltage. This part uses engine oil to adjust camshaft timing (variable valve timing). A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I drive with code P2093?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2093?
Common possibilities to test include: failed camshaft timing (vvt) solenoid; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.