P2098 Post Catalyst Fuel Trim System Too Lean Bank 2
What it means
The oxygen sensor after the catalytic converter on bank 2 (the side of the engine opposite cylinder 1) shows the engine has been running too lean for the computer's fine-tuning to fix. This usually points to a problem before the converter, such as an exhaust or vacuum leak.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Fix any other fuel trim, misfire or O2 sensor codes first
- Check for exhaust leaks ahead of and around the O2 sensors
- Compare upstream and downstream O2 sensor readings and fuel trims
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- Possible drop in fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonExhaust leak near the oxygen sensors
- CommonVacuum or intake air leak
- CommonFaulty downstream oxygen sensor
- PossibleWorn catalytic converter
- PossibleLow fuel pressure or clogged injectors
Typical repair once the cause is confirmed
Find and repair the leak first; replace the downstream O2 sensor or catalytic converter only after testing.
Common questions
What does P2098 mean?
The oxygen sensor after the catalytic converter on bank 2 (the side of the engine opposite cylinder 1) shows the engine has been running too lean for the computer's fine-tuning to fix. This usually points to a problem before the converter, such as an exhaust or vacuum leak.
Can I drive with code P2098?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2098?
Common possibilities to test include: exhaust leak near the oxygen sensors; vacuum or intake air leak; faulty downstream oxygen sensor; worn catalytic converter. A shop should confirm the cause before replacing parts.