P20EE SCR NOx Catalyst Efficiency Below Threshold Bank 1
What it means
The diesel exhaust treatment system (SCR) on bank 1 isn't cutting NOx pollution as much as it should. Bad DEF fluid, a faulty NOx sensor or a worn SCR catalyst are typical reasons.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check DEF quality with a refractometer
- Compare upstream and downstream NOx sensor readings
- Run a DEF dosing test and inspect the injector
Signs you may notice
- Check engine light on
- DEF or emissions warning on the dash
- A countdown to reduced speed may start if not repaired
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonPoor quality, diluted or old DEF fluid
- CommonFaulty NOx sensor
- CommonClogged or crystallized DEF injector
- PossibleWorn or contaminated SCR catalyst
- PossibleExhaust leak near the sensors
Typical repair once the cause is confirmed
Fix DEF quality, sensor or injector problems first; replace the SCR catalyst only after testing.
Where it shows up
- Frequently seen on modern diesel pickups such as Ram Cummins, Ford Power Stroke and GM Duramax
Common questions
What does P20EE mean?
The diesel exhaust treatment system (SCR) on bank 1 isn't cutting NOx pollution as much as it should. Bad DEF fluid, a faulty NOx sensor or a worn SCR catalyst are typical reasons.
Can I drive with code P20EE?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P20EE?
Common possibilities to test include: poor quality, diluted or old def fluid; faulty nox sensor; clogged or crystallized def injector; worn or contaminated scr catalyst. A shop should confirm the cause before replacing parts.