P2116 Throttle/Pedal Position Sensor E Minimum Stop Performance
What it means
Throttle or pedal position sensor E isn't reading what the computer expects when the throttle or pedal is fully released. The resting position may be off or the sensor may be worn.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Clean the throttle body and check that it closes fully
- Run a throttle position relearn with a scan tool
Signs you may notice
- Check engine light on
- Idle too high or too low
- Possible reduced power mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonCarbon buildup keeping the throttle from closing fully
- CommonWorn throttle or pedal position sensor
- PossibleSticking pedal or throttle return spring
- PossibleThrottle relearn not done after cleaning or battery disconnect
Typical repair once the cause is confirmed
Clean the throttle and run a relearn; replace the throttle body or pedal if the reading is still off.
Common questions
What does P2116 mean?
Throttle or pedal position sensor E isn't reading what the computer expects when the throttle or pedal is fully released. The resting position may be off or the sensor may be worn.
Can I drive with code P2116?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2116?
Common possibilities to test include: carbon buildup keeping the throttle from closing fully; worn throttle or pedal position sensor; sticking pedal or throttle return spring; throttle relearn not done after cleaning or battery disconnect. A shop should confirm the cause before replacing parts.