P2122 Throttle/Pedal Position Sensor/Switch D Circuit Low
What it means
One of the sensors that tells the computer how far you are pressing the gas pedal (sensor D) is reading lower voltage than expected. It's usually the pedal sensor or its wiring.
Can I keep driving?
Use care. A bad pedal sensor signal can limit power or make the car slow to respond, which is risky when merging or crossing traffic. If the pedal barely works or it stalls, have it towed. Otherwise drive directly to a shop soon and avoid highways.
What to test before replacing parts
Check pedal sensor D's reference voltage, ground and signal wiring for a short or open, and watch both pedal signals on a scanner before replacing the pedal assembly.
- Inspect the pedal connector and wiring under the dash
- Watch pedal sensor readings while slowly pressing the pedal
- Check the 5-volt reference and ground at the pedal
Signs you may notice
- Check engine light on
- Reduced engine power or limp mode
- Poor or no response to the gas pedal
- Possible stalling
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed accelerator pedal position sensor
- CommonDamaged wiring or connector at the pedal
- CommonWire shorted to ground
- PossibleLoose or corroded pedal connector
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any wiring problems; otherwise replace the accelerator pedal assembly.
Known on these vehicles
Common questions
What does P2122 mean?
One of the sensors that tells the computer how far you are pressing the gas pedal (sensor D) is reading lower voltage than expected. It's usually the pedal sensor or its wiring.
Can I drive with code P2122?
Use care. A bad pedal sensor signal can limit power or make the car slow to respond, which is risky when merging or crossing traffic. If the pedal barely works or it stalls, have it towed. Otherwise drive directly to a shop soon and avoid highways.
What causes P2122?
Common possibilities to test include: failed accelerator pedal position sensor; damaged wiring or connector at the pedal; wire shorted to ground; loose or corroded pedal connector. A shop should confirm the cause before replacing parts.