P2124 Throttle/Pedal Position Sensor/Switch D Circuit Intermittent
What it means
The signal from the throttle/pedal position sensor D keeps dropping out or jumping around. This sensor helps tell the computer how far the gas pedal is pressed or how open the throttle is. A loose connection or a damaged wire is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Wiggle the harness and connector while watching live data for dropouts
- Inspect the pedal or throttle sensor wiring along its whole route
Signs you may notice
- Check engine light on
- Reduced engine power or limp mode
- Poor or no response to the gas pedal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLoose or corroded connector
- CommonChafed wire that opens or shorts as the engine moves
- PossibleFailing accelerator pedal position sensor (usually part of the pedal)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the accelerator pedal position sensor (usually part of the pedal).
Common questions
What does P2124 mean?
The signal from the throttle/pedal position sensor D keeps dropping out or jumping around. This sensor helps tell the computer how far the gas pedal is pressed or how open the throttle is. A loose connection or a damaged wire is the usual reason.
Can I drive with code P2124?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2124?
Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing accelerator pedal position sensor (usually part of the pedal). A shop should confirm the cause before replacing parts.