Home › Code lookup › P2125
Powertrain code · Speed and idle control

P2125 Throttle/Pedal Position Sensor/Switch E Circuit

How urgent? Get it checked in the next few days

What it means

The engine computer has found a problem in the circuit for the throttle/pedal position sensor E, which helps tell the computer how far the gas pedal is pressed or how open the throttle is. It usually points to wiring, a connector or the sensor itself.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the pedal or throttle sensor connector and wiring for damage or corrosion
  2. Check the sensor power, ground and signal with a meter

Signs you may notice

  • Check engine light on
  • Reduced engine power or limp mode
  • Poor or no response to the gas pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty accelerator pedal position sensor (usually part of the pedal)
  • CommonDamaged, corroded or unplugged connector
  • PossibleBroken or chafed wiring
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the accelerator pedal position sensor (usually part of the pedal).

Repair costInsufficient verified pricing for this vehicle and repair
Replace accelerator pedal assembly. Prepare an itemized shop request.
Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2125 mean?

The engine computer has found a problem in the circuit for the throttle/pedal position sensor E, which helps tell the computer how far the gas pedal is pressed or how open the throttle is. It usually points to wiring, a connector or the sensor itself.

Can I drive with code P2125?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2125?

Common possibilities to test include: faulty accelerator pedal position sensor (usually part of the pedal); damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.