Home › Code lookup › P2127
Powertrain code · Speed and idle control

P2127 Throttle/Pedal Position Sensor/Switch E Circuit Low

How urgent? Get it checked in the next few days

What it means

One of the sensors that tells the computer how far you are pressing the gas pedal (sensor E) is reading lower voltage than expected. It's usually the pedal sensor or its wiring.

Can I keep driving?

Use care. The computer may cut power because it can't trust the gas pedal signal, making the car slow to respond when you need it. If the pedal barely works or the engine stalls, have it towed. If it drives normally, go straight to a shop soon and stay off highways.

What to test before replacing parts

Check pedal sensor E's reference voltage, ground and signal wiring for a short to ground or open, and compare both pedal signals on a scanner before replacing the pedal assembly.

  1. Inspect the pedal connector and wiring under the dash
  2. Watch pedal sensor readings while slowly pressing the pedal
  3. Check the 5-volt reference and ground at the pedal

Signs you may notice

  • Check engine light on
  • Reduced engine power or limp mode
  • Poor or no response to the gas pedal
  • Possible stalling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed accelerator pedal position sensor
  • CommonDamaged wiring or connector at the pedal
  • CommonWire shorted to ground
  • PossibleLoose or corroded pedal connector
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any wiring problems; otherwise replace the accelerator pedal assembly.

Repair costInsufficient verified pricing for this vehicle and repair
Replace accelerator pedal assembly. Prepare an itemized shop request.
Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2127 mean?

One of the sensors that tells the computer how far you are pressing the gas pedal (sensor E) is reading lower voltage than expected. It's usually the pedal sensor or its wiring.

Can I drive with code P2127?

Use care. The computer may cut power because it can't trust the gas pedal signal, making the car slow to respond when you need it. If the pedal barely works or the engine stalls, have it towed. If it drives normally, go straight to a shop soon and stay off highways.

What causes P2127?

Common possibilities to test include: failed accelerator pedal position sensor; damaged wiring or connector at the pedal; wire shorted to ground; loose or corroded pedal connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.