P2128 Throttle/Pedal Position Sensor/Switch E Circuit High
What it means
The signal from the throttle/pedal position sensor E is higher than the computer expects. This sensor helps tell the computer how far the gas pedal is pressed or how open the throttle is. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the pedal or throttle sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- Reduced engine power or limp mode
- Poor or no response to the gas pedal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed accelerator pedal position sensor (usually part of the pedal)
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the accelerator pedal position sensor (usually part of the pedal).
Common questions
What does P2128 mean?
The signal from the throttle/pedal position sensor E is higher than the computer expects. This sensor helps tell the computer how far the gas pedal is pressed or how open the throttle is. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P2128?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2128?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed accelerator pedal position sensor (usually part of the pedal); wire shorted to a power source. A shop should confirm the cause before replacing parts.