P2132 Throttle/Pedal Position Sensor/Switch F Circuit Low
What it means
The signal from the throttle/pedal position sensor F is lower than the computer expects. This sensor helps tell the computer how far the gas pedal is pressed or how open the throttle is. A wire shorted to ground or a failed sensor is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the pedal or throttle sensor wiring for rubbed-through or pinched spots
- Unplug the sensor and see if the reading changes, which helps separate wiring from sensor
Signs you may notice
- Check engine light on
- Reduced engine power or limp mode
- Poor or no response to the gas pedal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal or reference wire shorted to ground
- CommonFailed accelerator pedal position sensor (usually part of the pedal)
- PossibleCorroded or damaged connector
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the accelerator pedal position sensor (usually part of the pedal).
Common questions
What does P2132 mean?
The signal from the throttle/pedal position sensor F is lower than the computer expects. This sensor helps tell the computer how far the gas pedal is pressed or how open the throttle is. A wire shorted to ground or a failed sensor is the usual reason.
Can I drive with code P2132?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2132?
Common possibilities to test include: signal or reference wire shorted to ground; failed accelerator pedal position sensor (usually part of the pedal); corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.