P2136 Throttle/Pedal Position Sensor/Switch A/C Voltage Correlation
What it means
Two position sensors that should agree with each other (sensors A and C) are giving different readings. The computer uses this check to make sure the throttle is safe.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the throttle body and pedal connectors for corrosion or loose pins
- Watch both sensor readings together in live data while moving the throttle or pedal
Signs you may notice
- Check engine light on
- Reduced engine power or limp mode
- Poor or no response to the gas pedal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing throttle body or pedal position sensor
- CommonWiring or connector problem
- PossibleShared 5-volt reference circuit shorted by another sensor
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair wiring or connector problems; otherwise replace the throttle body or pedal assembly, whichever holds the two sensors.
Common questions
What does P2136 mean?
Two position sensors that should agree with each other (sensors A and C) are giving different readings. The computer uses this check to make sure the throttle is safe.
Can I drive with code P2136?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2136?
Common possibilities to test include: failing throttle body or pedal position sensor; wiring or connector problem; shared 5-volt reference circuit shorted by another sensor; engine computer problem (rare). A shop should confirm the cause before replacing parts.