Home › Code lookup › P2138
Powertrain code · Speed and idle control

P2138 Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation

How urgent? Get it checked in the next few days

What it means

Two position sensors that should agree with each other (sensors D and E) are giving different readings. On most cars these are the two sensors in the gas pedal.

Can I keep driving?

Use care. The two gas pedal sensor signals disagree, so the computer often limits power. If the car barely responds, stalls or idles rough, don't drive it in traffic; have it towed. If it drives normally, go straight to a shop soon and avoid highways.

What to test before replacing parts

Compare both pedal sensor signals on a scanner while slowly pressing the pedal, and check the pedal connector, wiring and grounds before replacing the pedal assembly.

  1. Inspect the throttle body and pedal connectors for corrosion or loose pins
  2. Watch both sensor readings together in live data while moving the throttle or pedal
  3. Wiggle the harness while watching for dropouts

Signs you may notice

  • Check engine light on
  • Reduced engine power or limp mode
  • Poor or no response to the gas pedal
  • Rough idle or stalling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing accelerator pedal position sensor
  • CommonPedal wiring or connector problem
  • CommonLoose or corroded connector
  • PossibleShared 5-volt reference circuit shorted by another sensor
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair wiring or connector problems; otherwise replace the throttle body or pedal assembly, whichever holds the two sensors.

Repair costInsufficient verified pricing for this vehicle and repair
Replace accelerator pedal assembly. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2138 mean?

Two position sensors that should agree with each other (sensors D and E) are giving different readings. On most cars these are the two sensors in the gas pedal.

Can I drive with code P2138?

Use care. The two gas pedal sensor signals disagree, so the computer often limits power. If the car barely responds, stalls or idles rough, don't drive it in traffic; have it towed. If it drives normally, go straight to a shop soon and avoid highways.

What causes P2138?

Common possibilities to test include: failing accelerator pedal position sensor; pedal wiring or connector problem; loose or corroded connector; shared 5-volt reference circuit shorted by another sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.