Home › Code lookup › P2143
Powertrain code · Emissions

P2143 Exhaust Gas Recirculation Vent Control Circuit/Open

How urgent? Book a check when convenient

What it means

The engine computer can't properly control the EGR vent solenoid, which vents vacuum from the EGR valve so it can close. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the EGR vent solenoid connector and wiring
  2. Check for power at the connector and measure the part's resistance

Signs you may notice

  • Check engine light on
  • Possible rough idle if the EGR valve stays open

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed EGR vent solenoid
  • CommonBroken wire or unplugged connector
  • PossibleBlown fuse or bad relay feeding the circuit
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the EGR vent solenoid.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EGR vent solenoid. Prepare an itemized shop request.

Common questions

What does P2143 mean?

The engine computer can't properly control the EGR vent solenoid, which vents vacuum from the EGR valve so it can close. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I drive with code P2143?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2143?

Common possibilities to test include: failed egr vent solenoid; broken wire or unplugged connector; blown fuse or bad relay feeding the circuit; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.